Installation and Removal of the Climbing Ring

If you encounter situations where the machine fails to climb walls or slips on them, you can install the climbing ring assembly included in the packaging box.

Climbing Ring Installation:
1.Turn off the robot.
2.Remove the brush roller from the robot.
3.Wet the climbing ring until the sponge becomes soft and moist (demonstrate by squeezing the sponge with your hand).
4.Align the climbing ring with the slot, pinch the clips on both sides of the climbing ring, install it, and ensure it is properly seated. Then, take the matching roller brush rubber, align the silicone clips with the slot openings, and secure the new roller brush rubber to both sides of the climbing ring assembly
5.Rotate manually to ensure smooth operation, completing the installation.

Climbing Ring Removal:
1.Turn off the robot.
2.Remove the segmented brush roller from the robot.
3.Locate the clips on both sides of the climbing ring, pinch them and remove the climbing ring from the roller, install the integrated brush roller, and Check if the clips and slots are aligned.
4. Rotate manually to ensure smooth operation, completing the replacement.