What should I do if I run out of grass rope?
Updated on 2026/01/28
If the trim cord is depleted, replacement instructions can be found on YouTube or in the manual:
(1) Press and hold the "Start" button on the machine for 5 seconds to lower the trim head. Then stand the machine upright or flip it over. During flipping, use the original radar lens cover to protect the laser lens.
(2) Remove the screws from the trim cord cover.
(3) Pinch the tabs with indented markings at both ends of the trim line cover and pull it outward to remove;
(4) Remove the depleted trim line roll. Pull a section of the new trim line roll's end through the circular hole, then install the new roll securely;
(5) Replace the trim line cover and tighten the screws;
(6) If the exposed trim line is too short, use the release button on the outer edge of the cover. Press and hold to extend the line;
(7) After replacement, reassemble the machine.
(1) Press and hold the "Start" button on the machine for 5 seconds to lower the trim head. Then stand the machine upright or flip it over. During flipping, use the original radar lens cover to protect the laser lens.
(2) Remove the screws from the trim cord cover.
(3) Pinch the tabs with indented markings at both ends of the trim line cover and pull it outward to remove;
(4) Remove the depleted trim line roll. Pull a section of the new trim line roll's end through the circular hole, then install the new roll securely;
(5) Replace the trim line cover and tighten the screws;
(6) If the exposed trim line is too short, use the release button on the outer edge of the cover. Press and hold to extend the line;
(7) After replacement, reassemble the machine.